Advertisement
Socket in the front centre console
To open: open the stowage compartment
X
(
page 309).
Y
Lift up the cover of the socket.
X
To close: push the cover of the stowage com-
X
partment closed.
Socket in the rear-compartment centre
console
Pull the cover out by the top of its handle
X
edge.
Lift up the cover of the socket.
X
230 V socket
Important safety notes
G
DANGER
When a suitable device is connected, the
230 V power socket will be carrying a high
voltage. You could receive an electric shock if
the connector cable or the 230 V power
socket is pulled out of the trim or is damaged
or wet. There is a risk of fatal injury.
Use only connector cables that are dry and
R
free of damage.
When the ignition is off, make sure that the
R
230 V power socket is dry.
Immediately have the 230 V power socket
R
checked or replaced at a qualified special-
ised workshop if it is damaged or has been
pulled out of the trim.
Never plug the connector cable into a 230 V
R
power socket that is damaged or has been
pulled out of the trim.
G
DANGER
If you reach into the power socket or plug
inappropriate devices into the power socket,
you could receive an electric shock. There is a
risk of fatal injury.
Only attach appropriate objects to the power
socket.
!
Note that work and repairs on the 230 V
power socket should only be carried out by
qualified specialist personnel.
General notes
The 230 V power socket provides an alternating
voltage of 230 V so that small electronic devices
can be connected. These devices, such as
games consoles, chargers and laptops, must not
consume more than a maximum of 150 watts
altogether.
Do not connect any multiple socket outlets to
the 230 V power socket.
Requirements for operating these devices:
the electronic device that you connect has a
R
suitable connector and conforms to stand-
ards specific to the country you are in
the electronic device connector is plugged
R
into the 230 V power socket
the maximum wattage of the device to be
R
connected must not exceed 150 watts
the on-board voltage is within a permissible
R
voltage range
the 12 V socket in the front centre console is
R
working properly (
Y
Using the 230 V power socket
To switch on: switch the ignition on.
X
Open flap =.
X
Insert the electronic device connector into
X
230 V power socket :.
Indicator lamp ; lights up.
To switch off: remove the connector from
X
230 V power socket :.
Make sure that you do not pull on the cable.
Features
page 317)
Z
317
Advertisement
