Advertisement
Care
330
Always switch off the windscreen wipers and
the ignition before cleaning the windscreen or
wiper blades.
!
Do not pull on the wiper blade. Otherwise,
the wiper blade could be damaged.
!
Do not clean wiper blades too often and do
not rub them too hard. Otherwise, the graph-
ite coating could be damaged. This could
cause wiper noise.
!
Hold the wiper arm securely when folding
back. The windscreen could be damaged if
the wiper arm hits against it suddenly.
Fold the wiper arms away from the wind-
X
screen (
page 126).
Y
Clean the wiper blades carefully using a damp
X
cloth.
Fold the windscreen wipers back again before
X
switching on the ignition.
Cleaning the exterior lighting
!
Only use cleaning agents or cleaning cloths
that are suitable for plastic lenses. Unsuitable
cleaning agents or cleaning cloths could
scratch or damage the plastic lenses of the
exterior lighting.
Clean the plastic lenses of the exterior light-
X
ing using a wet sponge and a mild cleaning
agent, e.g. Mercedes-Benz car shampoo or
cleaning cloths.
Cleaning the mirror turn signal
!
Only use cleaning agents or cleaning cloths
that are suitable for plastic lenses. Unsuitable
cleaning agents or cleaning cloths could
scratch or damage the plastic lenses of the
mirror turn signals.
Clean the plastic lenses of the mirror turn sig-
X
nals in the exterior mirror housing using a wet
sponge and mild cleaning agent, e.g.
Mercedes-Benz car shampoo or cleaning
cloths.
Cleaning the sensors
!
If you clean the sensors with a high-pressure
cleaner, make sure that you keep a distance
of at least 30 cm between the vehicle and the
high-pressure cleaner nozzle. Information
about the correct distance is available from
the equipment manufacturer.
Clean sensors : of the driving systems with
X
water, car shampoo and a soft cloth.
Cleaning the reversing camera and
360° camera
!
Do not clean the camera lens and the area
around the reversing camera or 360°camera
with a high-pressure cleaner.
Make sure that the vehicle is stationary and
X
that the key is in position 2 in the ignition lock.
Open the camera cover for cleaning via the
X
multimedia system (see separate operating
instructions).
To clean the camera: use clean water and a
X
soft cloth to clean camera lens :.
360° camera: if you drive at speeds above
30 km/h or with the key in position 0 or 1 in the
ignition lock, the cover of the 360° camera
closes automatically.
Advertisement
