Table of Contents
Advertisement
6.
Press the cover cap in again to open it
slightly.
7.
Pull on the cover cap until the door opens.
The other doors must be unlocked from the in‐
side.
Locking via the side door lock
Side door lock in the driver's door.
1.
Slightly open the driver's door.
2.
Lock the side door lock with the integrated
key.
3.
Close the driver's door.
If necessary, lock the other doors from the re‐
spective side door lock as well.
Online Edition for Part no. 01405A38CB9 - VI/21
Opening and closing
Alarm system
The activated alarm system is triggered when
the door is opened after being unlocked via the
door lock.
The alarm system is not switched on if the vehi‐
cle is locked with the integrated key.
Emergency detection of the vehicle
key
Drive-ready state cannot be switched on if the
vehicle key has not been detected.
If this happens, proceed as follows:
1.
Hold the rear side of the vehicle key against
the mark on the steering column. Pay atten‐
tion to the display in the instrument cluster.
2. ▷
If the vehicle key is detected:
Switch on drive-ready state within 10 sec‐
onds.
▷
If the vehicle key is not detected:
Slightly change the position of the vehicle
key and repeat the procedure.
Malfunction
A Check Control message is shown where appli‐
cable.
It may be difficult for the vehicle to detect the ve‐
hicle key in some conditions, including the
following:
▷
The battery of the vehicle key is discharged.
▷
Disruption of the radio link by transmission
masts or other equipment transmitting pow‐
erful signals.
CONTROLS
93
Advertisement
Table of Contents
