Controlling Your Tv Or Av Amplifier (Receiver) With The Supplied Remote - Sony DVP-NC600 Operating Instructions Manual

Controlling Your TV or AV
Amplifier (Receiver) with
the Supplied Remote
By adjusting the remote signal, you can
control your TV or AV amplifier (receiver)
with the supplied remote.
If you connect the player with an AV
amplifier (receiver), you can control the
volume with the supplied remote.
Notes
• Depending on the units being connected, you may
not be able to control your TV or AV amplifier
(receiver) using some of the buttons below.
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote, the
code number may be reset to the default setting.
Reset the appropriate code number.
Controlling TVs with the remote
1 2
Number
4 5
buttons*
7 8
0
1
Hold down TV ?/1, and enter your TV's
manufacturer's code (see the table)
using the number buttons.
2
Release TV ?/1.
TV ?/1
3
TV/VIDEO
6
9
VOL +/–
Code number of controllable TVs
If more than one code number is listed, try
entering them one at a time until you find the
one that works with your TV.
Manufacturer Code number
Sony (default) 01
Grundig 11
Hitachi 24
Loewe 45
Nokia 15, 16, 69
Panasonic 17, 49
Philips 06, 07, 08
Saba 12, 13
Samsung 22, 23
Sanyo 25
Sharp 29
Telefunken 36
Thomson 43
Toshiba 38
Controlling the TV
You can control your TV using the buttons
below.
By pressing You can
TV ?/1 Turn the TV on or off
VOL (volume) Adjust the volume of the TV
+/–
TV/VIDEO Switch the TV's input source
between the TV and other input
sources
* Use the number buttons only to enter the code
number of controllable TVs.
61