Nokia RM-291 Service Manual page 146

Nokia Customer Care
Hardware requirements for auto tuning:
• PC (Windows 2000/NT) with GPIB card
• Power supply
• Product specific module jig
• Cables: 3 (alt.1) RF cable, 1 GPIB cable and DAU-9S
• Signal analyser (TX), signal generator (RX) and RF-splitter
Copy the two phone specific ini-files, for example
specific folder, for example
Steps
1. Make sure the phone (in the jig) is connected to the equipment. Else, some menus will not be shown in
Phoenix.
2. The first time you are using automatic tuning on this phone model, on this computer, you will have to
Set loss for cables and jigs.
3. To go to autotune, select
4. If you need more assistance, please refer to the Phoenix
Page 7 –8
Figure 94 Auto tuning concept with CMU200
Figure 95 Auto tuning concept with RX and TX tuning devices and splitter
\Phoenix\products\RM-13\ .
Tuning (Alt-U) > Auto-Tune (Alt-A) from the menu.
COMPANY CONFIDENTIAL
Copyright © 2007 Nokia. All rights reserved.
or one device including all.
rm_13_tunings.ini and autotune_RM-13.ini, to a phone
Help .
RM-291
RF troubleshooting
Issue 1