Troubleshooting - RIDGID RE 60 Manual

RE 60 Electrical Tool
For EC Countries: Do not dispose of elec-
trical equipment with household waste!
According to the European Guideline 2002/ -
96/ EC for Waste Electrical and Electronic
Equipment and its implementation into nation-
al legislation, electrical equipment that is no
longer usable must be collected separately and disposed
of in an environmentally correct manner.

Troubleshooting

SYMPTOM POSSIBLE REASONS
Battery is completely discharged or battery has
Tool will not turn ON
failed.
when ON/OFF button is
pressed.
Battery not properly inserted into handle of tool.
Tool will not run when
trigger is depressed.
Battery charge is too low.
Green light flashes.
Tool turns OFF either
when trigger is
depressed or in the
Tool or battery is too cold or too hot.
middle of a cycle. Red
LED glows.
Yellow LED blinks repeat-
edly as long as tool is
Scheduled maintenance/recalibration is required
turned ON and tool func-
after 30,000 cycles.
tions properly.
Yellow LED glows con-
tinuously and tool will Scheduled maintenance/recalibration is mandato-
not begin press cycle ry after 32,000 cycles. Tool is "locked" and will not
when trigger switch is function until serviced..
depressed.
Yellow LED glows when
Tool malfunction detected.
tool is turned ON.
Used wrong interchangeable head/insert for the
cable size or material.
The connections
produced are not
The tool was not square to the connector.
complete.
Tool is in need of repair.
27
SOLUTION
Insert fully charged battery/recharge battery.
Check to assure battery is fully inserted.
Insert fully charged battery/recharge battery.
Bring tool and battery to correct operating range
between 23 °F (-5 °C) and 122 °F (50 °C) by allow-
ing the tool to sit in a conditioned room
Contact RIDGID Technical Service Department at
(800) 519-3456 for nearest Authorized Service
center.
Contact RIDGID Technical Service Department at
(800) 519-3456 for nearest Authorizedl Service
center.
Remove and reinsert fully charged battery. Be sure
to repress fitting. If LED continues to glow,Contact
RIDGID Technical Service Department at (800)
519-3456 for nearest Authorized Service center.
Install the correct interchangeable head/insert .
Redo the joint. Make sure that the tool is square
to the connector.
Contact RIDGID Technical Service Department at
(800) 519-3456 for nearest Authorized Service
center.
Troubleshooting (Continued)
SYMPTOM POSSIBLE REASONS
Oil leaks from tool. Seal or mechanical problems.
Motor runs but tool will
Oil level low.
not complete a cycle.
Dies stop during opera-
Oil level low.
tion.
RE 60 Diagnostic Codes
LED Status Description
Green
Glows Tool is ON.
Blinks Battery needs charging..
Red
Glows Out of temperature range -10 °C to +50 °C.
Blinks Service indicator after 30,000 cycles. NOTE: Tool will lock after 32,000 cycles.
Yellow
Glows Machine is locked – Service after 32,000 cycles or after a tool malfunction.
Figure 7 – LED Diagnostic Codes
RE 60 Electrical Tool
SOLUTION
Contact RIDGID Technical Service De
partment at
(800) 519-3456 for nearest Authorized Service
center.
Contact RIDGID Technical Service De partment at
(800) 519-3456 for nearest Authorized Service
center.
Contact RIDGID Technical Service De partment at
(800) 519-3456 for nearest Authorized Service
center.
c I o n
28