Table of Contents
Advertisement
Troubleshooting
SYMPTOM
Tool will not turn ON when switch is
pressed.
Jaws are locked onto fitting.
The pressed connections produced
are not complete.
LED Display Status
LED Green Light
LED White Light
Figure 11 – LED Diagnostic Codes
Service And Repair
WARNING
Improper service or repair can make tool unsafe
to operate.
Service and repair on the RP 306 Press Tool must
be performed by a RIDGID Independent Press Tool
Service Center.
For information on your nearest RIDGID Authorized
Independent Service Center or any service or repair
questions see Contact Information section in this
manual.
999-995-220.10_REV. B
POSSIBLE REASONS
Battery is completely discharged or
battery has failed.
Battery not properly inserted into
handle of tool
Correctly insert AC adapter into tool
Press was not successfully completed.
Used wrong jaws for the tube size or
material.
The tool was not square to the tube.
Jaw contour was not aligned with the
fitting contour.
Tool is in need of repair.
STATUS
On
Normal.
Flashing
The battery is low and needs to be replaced.
Off
The machine has failed and needs to be repaired.
On
It is always on when the green light is always on.
Off
The white light is off one minute after the green light off.
The green light and the white light are off at the same time when the machine fails,
and it needs to be repaired.
RP 306 Press Tools
SOLUTION
Insert fully charged battery/replace battery.
Check to assure battery/adapter is fully
inserted.
Push pressure release valve to remove jaws
from fitting. Inspect and repress fitting.
Install the correct jaws.
Redo the joint with new fitting and new tube.
Make sure that the tool is square to the tube.
Redo the joint with new tube and new fitting.
Make sure the jaw contour is aligned with the
fitting contour.
Contact RIDGID Technical Service Department
at 400-820-5695 for nearest Authorized Press
Tool Service center.
REMARK
11
Advertisement
Table of Contents
