Connecting/Removing External Dust Extraction; Operation; Switching On/Off; Adjusting The Oscillation Rate - Parkside PMFS 200 B2 Original Instructions Manual

GB MT
Connecting/removing exter-
nal dust extraction
Connecting external dust
extraction:
1. Slide the adapter for external
dust extraction (11) all the way
onto the connection for dust ex-
traction (6).
2. Connect the suction tube of a
vacuum cleaner (not included)
to the adapter for external dust
extraction (11).
Removing external dust
extraction
3. Disconnect the suction tube from
the adapter for external dust ex-
traction (11).
4. Disconnect the adapter for exter-
nal dust extraction (11).
If necessary, you can connect the
suction tube of a vacuum cleaner
directly to the device without an
adapter.

Operation

Switching on/off

Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
Connect the machine to the power
supply.
1. To switch on, push the on/off
switch (3) to position „I". The
tool will power on.
2. To switch off, push the on/off
switch (3) to position „O". The
tool will power off.
44

Adjusting the oscillation rate

The required oscillation rate depends on
the material to be processed and can be
determined through practical testing.
In order to regulate the oscillation
rate, use the oscillation frequency
controller (1):
1
lowest oscillation rate
MAX maximum oscillation rate.

Practical tips

When working with the ap-
pliance, always wear suita-
ble clothing and appropriate
protective equipment.
Prior to each use it must be
ensured that the appliance is
working correctly.
Personal protective equip-
ment and a fully functional
appliance reduce the risk of
injuries and accidents.
Always disconnect the plug from
the mains socket before working.
Danger of electric shock.

Sanding

• Move the appliance against the work-
piece once it is switched on.
• After machining, lift the sanding disc
up before turning off the device.
• Always lead the mains cable towards
the back and away from the device.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.