Advertisement
Quick Links
Advertisement
Related Manuals for NCR 7409-K312
Summary of Contents for NCR 7409-K312
- Page 1 7409-K312 Fixed Angle Mount Image Scanner Kit Instructions Issue A...
-
Page 2: Revision Record
Revision Record Issue Date Remarks July 2011 First issue... - Page 3 Introduction This kit provides an Imaging Scanner for the following terminals. NCR RealPOS 25 (7610) NCR RealPOS 50 (7611) The assembly installs on the front of the 7409-K035 Fixed Angle Mount. MS4980 Imaging Scanner Cable 497-0472847 Screw, 6-32 x 1/4, Phillips, PH...
-
Page 4: Installation Procedures
Installation Procedures 1. Remove the screws (2) in the sides of the Fixed Angle Mount. Hex Screw (One Each Side) 2. Rest the bottom of the display on the Display Support. Display Support... - Page 5 3. Remove the Blank Faceplate from the Fixed Angle Mount (2 screws). Blank Faceplate 4. Hook the bottom of the Fixed Angle Mount Faceplate and Image Scanner Assembly onto the bottom edge of the opening on the front of the Fixed Angle Mount and secure it with screws (2).
- Page 6 5. Remove the Cable Cover from the terminal and connect the cables to the terminal I/O Panel. a. Connect the scanner serial cable to an RS-232 Connector. The Imaging Scanner is a 5 Vdc device. Make sure the serial port Warning: is set to 5 V.
- Page 7 7610 Serial Port Jumper Settings COMB COMA COMC Ring Indicator 12 V * Default setting COMD Ring Indicator 12 V * Default setting 28687a...
- Page 8 7611 Serial Port Jumper Settings COMA COMB COMC COMD Ring Indicator 12 V * Default setting Ring Indicator 12 V * Default setting 28764...
- Page 9 6. Close the Cable Cover. 7. Close the Display onto the Fixed Angle Mount and secure it with screws (2). Hex Screw (One Each Side)