Revision Record Issue Date Remarks Sept 2012 First Issue July 2013 Complete revision...
Page 3
Introduction This kit provides an N5680 Imaging Scanner assembly for the NCR RealPOS 25 (7610) and the NCR REalPOS 50 (7611) terminals. The assembly installs on the front of the 7409‐K035 Fixed Angle Mount. Components Screw, 6-32 x 0.312, PH, Ph 006-8616637 N5680 Imager 497-0476023 Imager Bracket 497-0472700 Screw, 6-32 x 0.250, Phil, PH 006-8611016 Nut, KEPS, 8-32 006-8611143 Scanner Filler Plate 497-0471591 31477...
Installation Procedures 1. Remove the screws (2) in the sides of the Fixed Angle Mount. Screw (One Each Side) 32464 2. Rest the bottom of the display on the Display Support. Display Support 32465 Note: Place the Display Support behind the extension on then Display Hinge Bracket.
Page 5
3. Remove the Blank Faceplate from the Fixed Angle Mount (2 screws). 32468 Blank Face Plate Screws 4. Install the Faceplate and Scanner Assembly on the Fixed Angle Mount. Face Plate and Scanner Assembly 32469...
Page 6
5. Connect the USB Cable to the terminal I/O Panel. USB Ports 32470 6. Lower the Display back to the operating position on the Fixed Angle Mount and secure it with screws (2). Screw (One Each Side) 32471...