Table of Contents
Advertisement
Power Switch
SNAPSHOT
Button
Lock Button
Recording Start/Stop Button
MENU Wheel
Display
5S
–
OF F
5S
An i m .
VIDEO/MEMORY Switch
(Open the LCD monitor
to access this switch.)
Menu Screen
5-Second Recording
Record a vacation or an important event in 5-second
clips to keep the action moving. This function is
available only for tape recording.
1
Set the VIDEO/MEMORY Switch to "VIDEO", then
set the Power Switch to "
Lock Button located on the switch. Pull out the
viewfinder fully or open the LCD monitor fully.
2
Press the MENU wheel in. The Menu Screen
appears.
3
Rotate the MENU wheel to select "
and press it. The MANUAL Menu appears.
4
Rotate the MENU wheel to select "5S", and press
it. The Sub Menu appears.
5
Rotate the MENU wheel to select "5S", and press
it. Selection is complete. Rotate the MENU wheel to
select "
RETURN", and press it twice to close the
Menu Screen.
• "5S" appears.
6
Press the Recording Start/Stop Button. The tally
lamp lights and beep sounds to indicate the start of
recording, and after 5 seconds the camcorder enters
Record-Standby mode.
• Even if you press the Recording Start/Stop Button
again within 5 seconds after recording starts,
Record-Standby mode is not engaged.
7
To exit the 5S mode, select "OFF" in step 5.
To Take A Snapshot In The 5-Second Recording
Mode . . .
..... instead of pressing the Recording Start/Stop
Button in step 6, select the desired Snapshot
mode in the Menu Screen, then press SNAP-
SHOT. The camcorder records a 5-second still
(
pg. 20). When "5S" is set to "Anim."
(
pg. 29) this function is not available.
NOTE:
When "5S" is set to "Anim." in the Menu Screen the
5-second recording mode is not available. Animation
recording of a few frames only is taken instead
(
pg. 29).
35
EN
" while pressing down the
MANUAL",
Advertisement
Table of Contents
