Printing on special media
7
Envelope
Printing successfully on envelopes depends upon the quality of the envelopes.
To print an envelope, place it as shown in the following figure.
If envelopes are printed out with wrinkles, creases, or black bold lines, open
the rear cover and pull down the pressure lever on the side about 90
degrees and try printing again. Keep the rear cover opened during printing.
90˚
•
When selecting envelopes, consider the following factors:
-
Weight: should not exceed 90 g/m
-
Construction: should lie flat with less than 6 mm curl and should not
contain air.
-
Condition: should not be wrinkled, nicked, nor damaged.
-
Temperature: should resist the heat and pressure of the machine
during operation.
•
Use only well-constructed envelopes with sharp and well-creased folds.
90˚
1
1
Pressure lever
2
otherwise, jams may occur.
4. Media and Tray
74