Connections - Panasonic SC-HT640W Operating Instructions Manual

4
Radio and digital transceiver connections
STEP
AM loop antenna
≥ Using an outdoor antenna (optional) (➜ page 25).
AM loop antenna
Stand the antenna up on its base.
Place the antenna where reception is best.
Keep loose antenna cable away from other wires
and cables.
Loosen the terminal screw with
a Phillips-head screwdriver.
Black
White
Red
While pushing, insert the wire fully.
5
AC cord connections
STEP
Main unit
AC IN
AC power supply cord (included)
Conserving power
The main unit and the wireless surround speaker consume a small
amount of power when they are in standby mode [main unit: approx.
0.4 W, surround speaker: 0.5 W (in transmit mode), 1.2 W (in receive
mode)]. To save power when the unit is not to be used for a long time,
unplug it from the household AC outlet.
You will need to reset some memory items after plugging in the unit.
FM indoor antenna
Main unit
Click!
4
2 AC power supply cords
Wireless surround speaker
To household AC outlet
(AC 120 V, 60 Hz)
FM indoor antenna
Affix this end of the antenna where
reception is best.
Adhesive tape
Insert the digital transceiver
DIGITAL
TRANSCEIVER
LOOP
into the slot.
ANT GND
FM ANT
75 75
LOOP
Do not insert or remove
AM
while the main unit is on.
ANT
EXT
Re-tighten the terminal
screw.
AC power supply cord (included)
[Note]
The included AC power supply cords are for use with the main unit and
surround speaker only. Do not use them with other equipment. Also, do
not use cords for other equipment with the main unit or surround
speaker.
Digital transceiver
Digital transceiver
Insert fully until you
hear a click.
DIGITAL
TRANSMITTER
FM ANT
COMPONENT VIDEO OUT
75
P Y
B LOOP
S-VIDEO
OUT
AM
ANT
EXT
P
R VIDEO
OUT
To household AC outlet
(AC 120 V, 60 Hz)
7