Invacare ReaFocus User Manual page 19

It is now possible to remove the headrest and
reinsert it in the desired position without further
adjustments.
Adjusting the rear wheels
WARNING!
Safety risk
– When you have fitted the wheels in the correct
position, make sure that the nuts and screws
are tightened securely with a torque of 40Nm.
This is important for you own safety.
WARNING!
Safety risk
– Always remember to adjust the brakes, when
the rearwheel position has been changed.
CAUTION!
Damage to the product
When adjusting the position of the rearwheel, the
attachment clamps might be tightened unevenly
and cause the rearwheels to come in contact with
the armrests.
– Re-tighten the attachment screws alternately in
order to get the clamps even.
Height adjustment
C
A
1. Loosen the screw A.
2. Slide the clamp B up or down to the desired position.
A peg on the inside of the clamp fits in the holes
of the bar C.
3. Re-tighten the screws.
5 mm allen key
CAUTION!
Damage to the product
The clamps B might be tightened unevenly and
cause the rear wheels to scratch against the
armrests.
– Re-tighten the screws alternately in order to
get the clamps even and to prevent the wheels
from slanting.
1431580-C
B
Depth adjustment
WARNING!
Risk of tipping
– Do not position the rear wheels in front of the
backrest, this will increase the tip risk severely.
The rear wheel bar can be positioned in four different
locations in order to change the wheel balance. In
addition, the rear wheel can also be placed in front
of the rear wheel bar, or behind the rear wheel bar.
Front and rear position:
B
A
C
1. Loosen the screws A and B.
The screw heads should be visible before the
rear wheel bar is moved.
2. Push or pull the rear wheel bar D to the most front
or the most rear position.
3. Re-tighten the upper screw A first and then the lower
screw B.
The upper screw A will only lock securely when
it is fully inserted.
5 mm allen key
Middle positions:
A
C
1. Loosen the screws A and B.
The screw heads should be visible before the
rear wheel bar is moved.
2. Push or pull the rear wheel bar D to the position
between the markings E or F on the attachment.
3. Re-tighten the upper screw A first and then the lower
screw B.
The upper screw A will only lock securely when
it is fully inserted.
Options
D
B
D
19