Table of Contents
Advertisement
3.8.1 Angle adjustable backrest
1.
A
Loosen the screw A on the inside of the backrest
attachment.
2.
Loosen the screw B on the outside of the backrest
attachment.
3.
Turn the dial C to adjust the angle.
The angle can be adjusted 6˚ forward and 13˚
backward.
4. Tighten the screws again with 10 Nm.
5. Repeat the procedure on the opposite side.
5 mm allen key
1431580-C
3.8.2 Biangular backrest
The biangular backrest have two possible angle adjustments:
•
Angle adjustment on the upper joint
•
Angle adjustment on the lower joint
A
B
1. Loosen the screw A.
2. Adjust the upper joint to the desired angle.
3. Re-tighten the screw A with 10 Nm.
See section "Angle adjustable backrest" for
instructions on how to adjust the angle on the
lower joint B.
5 mm allen key
3.8.3 Reclining Backrest
The angle of the backrest can be adjusted in four steps (0°
to 30°) with the mechanical version, and step less with the
gas struts version.
WARNING!
Risk of injury
– Always make these adjustments before the
user settles down in the wheelchair to prevent
injuries.
– Invacare strongly recommends the use
of anti-tippers (available as an option) in
combination with all rear wheel positions when
you use your backrest with an angle of 12° and
more
CAUTION!
Risk of pinching or crushing fingers
There is always a risk of getting fingers pinched in
mechanical parts of the wheelchair.
– Be careful when activating the control levers of
the reclining backrest.
IMPORTANT!
– Push on the backrest canes before operating
the levers, this is to release the auto-locked
security system of the mechanical version.
WARNING!
Risk of tipping backwards
– Adjust the rear wheels to achieve a stable
position and use anti-tipper devices.
Product Overview
11
Advertisement
Table of Contents
