Registering Routes; Setting The Arrival Alarm - Furuno GP-80 Operator's Manual

Selecting Mark Shape/Line
Type
1) Press [MENU ESC] [2].
2) Press or to select Mark Shape (or
Mark Line).
3) Press t or s to select mark shape (or
mark line) desired.
4) Press [NU/CU ENT].
5) Press [MENU ESC].
Entering Event Mark
Press [EVENT MOB].
Entering MOB Mark
Press [EVENT MOB] until "Save MOB posi-
tion" appears (about three seconds).
Stopping/Starting Plotting
and Recording of Track
Press [PLOT ON/OFF]. "
recording is off.
Registering Waypoints
A waypoint can be entered four ways. Below
is the procedure for entry by the cursor.
1) Press [WPT RTE].
2) Press [1] to select Cursor.
3) Operate the cursor keys to place cursor on
position desired for waypoint.
4) Press [NU/CU ENT].
5) Press .
6) Press t or s to select mark shape.
7) Press [NU/CU ENT].
8) Enter comment (maximum 12 alphanu-
meric characters).
9) Press [NU/CU ENT].
" appears when
H
9 5 0 9 5 0 K O P U B . N O . O S E - 4 3 7 4 0 - A
( 0 0 0 0 , T A T A ) G P - 8 0

Registering Routes

1) Press [WPT RTE].
2) Press [5] to select Route Planning.
3) Press or to select route number.
4) Press s.
5) Enter waypoint number (three digits).
6) Press to enter next waypoint number.
7) Repeat steps 6 and 7 to complete the route.
8) Press [NU/CU ENT].
Setting/Cancelling
Destination
Destination can be set four ways. Below is the
method for setting destination by the cursor.
1) Press [GOTO].
2) Press [1] to select Cursor.
3) Place the cursor on position to set as desti-
nation.
4) Press [NU/CU ENT] twice.
To cancel destination, press [GOTO] [5]
[NU/CU ENT].

Setting the Arrival Alarm

1) Press [MENU ESC] [4].
2) Press or to select Arrival/Anchor.
3) Press t to select Arr.
4) Press to select Alarm Range.
5) Enter arrival alarm range.
6) Press [NU/CU ENT].
7) Press [MENU ESC].
The buzzer may be silenced by pressing
[CLEAR].