Resetting Trip And Odometer Distances - Furuno GP-32 Operator's Manual

7. OTHER FUNCTIONS
8. Use the cursor pad to choose data
desired and then press the [ENT] key.
NONE: No display
ODO: Odometer distance
TRIP: Trip distance
TIME: Time and date
POSN: Position
POWER: Power source voltage
SOG: Speed over ground
COG: Course over ground
WPT: Rng and brg to waypoint
XTE: Cross-track error
TTG: Time to go (to destination)
ETA: Estimated time of arrival
(at destination)
9. Control returns to the User display setup,
with "B" selected. Depending on the
selection made at step 5, set other
indications similar to how you did with "A".
10. Press the [MENU] key twice to finish.
Speedometer display
1. Press the [MENU] key once or twice to
open the menu.
2. Choose USER DISP and then press the
[ENT] key.
3. Choose 1 or 2 and then press the [ENT]
key.
4. Choose SPEEDOMETER and then press
the [ENT] key.
SPEEDOMETER
START FROM:
INTERVAL :
0 10
Start point
Interval
Speedometer menu
5. The cursor is selecting START FROM.
Press the [ENT] key.
6. Enter starting speed: Use ◄ or ► to
select location and ▲ or ▼ to enter value
and switch from plus to minus and vice
versa. The setting range is -99 to +99.
7. Press the [ENT] key, and the cursor shifts
to INTERVAL.
8. Press the [ENT] key.
42
+ 0
10
20 30 40
9. Enter scale interval: Use ◄ or ► to
choose location and ▲ or ▼ to enter
value. The setting range is 1 to 99.
10. Press the [ENT] key.
11. Press the [MENU] key twice to close the
menu.
7.12 Resetting Trip and
Odometer Distances
1. Press the [MENU] key once or twice to
open the menu.
2. Choose ERASE and then press the [ENT]
key.
3. Choose "RESET TRIP?" (or "RESET
ODO?") and then press the [ENT] key.
One of following displays appears.
RESET
TRIP METER?
ARE YOU SURE?
YES
RESET
ODOMETER?
ARE YOU SURE?
YES
Reset trip meter, odometer options
4. Press ◄ to choose YES and then press
the [ENT] key to reset distance to zero.
5. Press the [MENU] key twice to finish.
NO
NO