Connectors, Buttons, And Peripheral Interfaces - Fujitsu Stylistic CE CT2000 Series User Manual

CONNECTORS, BUTTONS, AND PERIPHERAL INTERFACES

Connectors and peripheral interfaces on the Stylistic
CT2000 Series CE Tablet allow the connection of a
variety of devices. Specific locations are illustrated in
Figures 1-2 through 1-5.
Connector/
Tablet Icon
Peripheral
DC input
connector
USB Port
PCMCIA
Card slot
Audio jack
Barcode
Scanner Port
Cradle
Interface Port No icon
Power button
Battery Release
Lock/Latch
Reset Button RESET
Table 1-3 provides a description of each peripheral
connector and buttons on the Stylistic CT2000 Series CE
Tablet. Each of the illustrated icons is either molded into
or printed on the tablet chassis.
Connect the AC adapter to power the system and charge the battery.
Connect Universal Serial Bus 1.1 devices to the Stylistic CT2000 Series
CE Tablet.
(Note that due to power constraints, there is a possibility that certain USB 1.1
devices will not operate properly with this port. If your device has its own power
adapter, it is recommended that you use it.)
Install a Type I or Type II PC Card.
Connect an external combination 2.5 mm microphone/headphone.
Note that a typical 3.5 mm audio plug will not fit this jack because it is
specifically designed for a telephone headphone/microphone hands-
free set.
Connect a device such as a bar code scanner. Note that this is a
specialized unit, and does not use a standard RS-232 port.
Connect the Stylistic CT2000 Series CE Cradle or other approved
docking device. Refer to documentation accompanying the docking
device for more information.
The Power button allows you to suspend tablet activity and resume
your tablet from suspend mode.
The battery release lock/latch allows you to remove the battery from
your system for external charging, storage, or replacement, and to lock
it into place when installed.
The recessed Reset button allows you to perform a warm boot of the
system.
Table 1-3. Peripheral Connectors/Interfaces
G e t t i n g S t a r t e d
Purpose
13