In A Rack - Cisco C1000-8T-2G-L Installation Manual

Switch Installation
Figure 14: Installing the Switch on a Wall

In A Rack

Installing the switch in a rack requires an optional bracket kit that is not included with the switch. You can
order these kits from your Cisco representative:
• 19-inch rack-mounting brackets (RCKMNT-19-CMPCT=)
• 23- and 24-inch rack-mounting brackets (RCKMNT-23-CMPCT=)
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to
ensure that the system remains stable. The following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the
Statement 1006
heaviest component at the bottom of the rack.
unit in the rack.
Cisco Catalyst 1000 Series 8-Port and 16-Port Switch Hardware Installation Guide
In A Rack
23