Hdmi (High Definition Multimedia Interface) Input Connection - Panasonic PT-50DL54 Operating Instructions Manual

O E
PTIONAL QUIPMENT
HDMI (High Definition Multimedia Interface)
Input Connection
About HDMI
HDMI is the first all-digital consumer electronics A/V
interface that supports several uncompressed standards,
enhanced and high definition video formats as well as
existing multi-channel audio format. One jack supports both
video and audio information. The HDMI/HDCP
be connected to an EIA/CEA 861
electronic device, such as a set top box or DVD player
equipped with an HDMI or DVI output connection. By
inputting a HDCP high definition picture source to the HDMI
terminal of this Projection Television, high definition
pictures can be displayed on the screen in their digital form.
The HDMI input terminal is not intended to be used with
personal computers. This
compatible with 1080i, 720p, 480p and 480i formats. Select
the output of the connecting device to match that of the
Projection Television.
Notes:
1. HDMI/HDCP = High Definition Multimedia Interface /
High-Bandwidth Digital Copy Protection.
2. EIA/CEA-861 =
transmission of uncompressed digital video including
high bandwidth digital content protection.
Compatible formats
This Projection Television is compatible with the following
formats. Please set the connecting device to the following
format.
Video signal
Format No. of pixels
1080i 1920 x 1080i
720p 1280 x 720p
720 x 480p
480p
640 x 480p
480i 720 x 480i
Audio signal
When digital audio is included in the HDMI connection,
the compatible sampling frequencies are 48 KHz /
44.1KHz / 32 KHz.
12
C
ONNECTIONS
1
input can
2
compliant consumer
Projection Television
Compliance covers profiles
Vertical scanning
frequency (Hz)
59.94 / 60
59.94 / 60
59.94 / 60
59.94 / 60
59.94 / 60
Connection diagram
Follow the diagram below to connect the Projection Television to a
set top box or a DVD player.
EXTERNAL DIGITAL
COMPONENT
Note: Use anolog audio when no
digital audio is available.
Incoming
Cable
AUDIO IN
S-VIDEO
VIDEO
is
AUDIO
* The connector on the Projection Television is HDMI Type A connector.
Procedure
• Connect the HDMI output from the set top box or a DVD
for
player to the HDMI input on the back of the Projection
Television.
• Press TV/VIDEO button on the remote control to select
HDMI input. The interface on the Projection Television is
an HDMI Type A connector.
• If the external device has a DVI output only, use a DVI to
HDMI adaptor cable*
the Projection Television. Also, connect the Audio Out
signal from the external device (set top box or DVD
player) to the Audio In*
• If you cannot display the picture because your Digital Set
Top Box does not have a Digital Out terminal setting, use
the Component Video Input (or the S-Video Input or
Video Input). In this case, the picture will be displayed as
an analog signal.
Notes:
*3. HDMI-DVI conversion cable (TY-SCH03DH) available
on Panasonic Website: www.panasonic.com (for
USA only).
*4. Please refer to page 22 for Audio setting detail.
HDMI
OUT
AUDIO OUT
R L
CABLES NOT INCLUDED
ANT
R-AUDIO IN-L
RGB 1 IN
AV IN
IN 1 IN 2 OUT IN 1 IN 2 IN 3
Y Y Y
VIDEO
P P P
B B B
P P P
R R R
L L L L L
AUDIO
R R R R R
COMPONENT VIDEO INPUT
TERMINALS ON BACK OF TELEVISION
3
to connect to the HDMI jack on
4
jacks below the HDMI input.