Out-Of-Band Access; Reset The Access Point - SMC Networks SMC2891W-AN Installation Manual

Out-of-Band Access

Reset the Access Point

If you cannot access the on-board configuration program via a serial port
connection:
◆
Be sure you have set the terminal emulator program to VT100 compatible, 8
data bits, 1 stop bit, no parity and 115200 Baud Rate.
◆
Check that the null-modem serial cable conforms to the pin-out connections
provided in "How to Connect to the Console Port" on page
If all other recovery measure fail, and the AP is still not functioning properly, take
any of these steps to reset the AP's hardware:
◆
Enter the "reload" command from the console interface.
◆
Restart the AP from the web interface.
◆
Perform a power reset.
– 49 –
Chapter A
| Troubleshooting
Out-of-Band Access
45.