Table of Contents
Advertisement
How to Connect to the Console Port
The RJ-45 Console port on the AP is used to connect to the AP for out-of-band
console configuration. The console device can be a PC or workstation running a VT-
100 terminal emulator, or a VT-100 terminal. An RJ-45-to-DB-9 cable is supplied
with the AP for connecting to a PC's RS-232 serial DB-9 DTE (COM) port.
Note:
To connect to notebooks or other PCs that do not have a DB-9 COM port, use
a USB to male DB-9 adapter cable (not included with the AP).
The following table describes the pin assignments used in the RJ-45-to-DB-9
console cable.
Table 6: Console Cable Wiring
AP's 8-Pin
Console Port
1 RXD (receive data)
3 TXD (transmit data)
4 SGND (signal ground)
No other pins are used.
The serial port's configuration requirements are as follows:
◆
Default Baud rate—115,200 bps
◆
Character Size—8 Characters
◆
Parity—None
◆
Stop bit—One
◆
Data bits—8
◆
Flow control—none
Null Modem
PC's 9-Pin
DTE Port
<---------------------
3 TXD (transmit data)
--------------------->
2 RXD (receive data)
-----------------------
5 SGND (signal ground)
– 45 –
Chapter 6
| AP Management
How to Connect to the Console Port
Advertisement
Table of Contents
