Yaesu FTM-200DE Instruction Manual page 53

LOW SPEED: If speed is lower than which is set, BEACONs are transmitted in time
intervals set in [SLOW RATE].
The units for speed can be set in Setup menu option [79 APRS UNITS].
HIGH SPEED: If speed is higher than which is set, BEACONs are transmitted in time
intervals set in [FAST RATE].
The units for speed can be set in Setup menu option [79 APRS UNITS].
SLOW RATE: BEACON transmission time interval when speed decreases below the
[LOW SPEED] setting.
FAST RATE: BEACON transmission time interval when speed increases above the
[HIGH SPEED] setting.
TURN ANGLE: Set the minimal value of changes in angle when the direction of movement
changes.
TURN SLOPE: Set the coefficient for automatically altering the angle that judges changes
in the direction of movement according to speed.
The higher the coefficient value setting, the greater the judgment angle is
when moving at slow speeds.
(If the real number for units of rotating tilt is set to 1/10, this is the same as
the unit setting used in HamHUD Nichetronix, LLC series transceivers.)
TURN TIME: Set the time limit until the next BEACON can be transmitted, after a
BEACON is transmitted upon detection of a change in time (Variable Rate
Beaconing) or direction (Corner Pegging).
Caution
If SmartBeaconing
TM
can be changed.
When changing parameters, be sure to adjust parameters of SmartBeaconing and DIGI PATH settings
for appropriate beacon transmission intervals to avoid communications channel congestion.
y 98 SORT FILTER
Sort function / filter function setting.
Setting Item: SORT:
FILTER: ALL / MOBILE / FREQUENCY / OBJECT/ITEM / DIGIPEATER /
Default: SORT:
FILTER: ALL
1 to 255 (X10)°/SPEED
is to be operated at different timings, the parameters of settings TYPE1 to TYPE3
TIME / CALLSIGN / DISTANCE
VoIP / WEATHER / YAESU / OTHER PACKET / CALL RINGER /
RANGE RINGER / 1200bps / 9600bps
TIME
52