APRS reception pop-up setting
This sets the display time of the pop-up that appears when a APRS beacon and message
is received.
1
Press and hold the [F menu] key → [75 APRS POPUP] → Press the DIAL knob.
2
Rotate the DIAL knob to select [BEACON], then press the DIAL knob.
3
Rotate the DIAL knob to select the pop-up time when a beacon is received, then press
the DIAL knob.
"OFF", "3 sec", "5 sec", "10 sec", "HOLD"
Factory default value: 10 sec
4
Rotate the DIAL knob to select [MESSAGE], then press the DIAL knob.
5
Rotate the DIAL knob to select the pop-up time when a message is received, then
press the DIAL knob.
"OFF", "3 sec", "5 sec", "10 sec", "HOLD"
Factory default value: 10 sec
6
Rotate the DIAL knob to select [MY PACKET], then press the DIAL knob.
7
Rotate the DIAL knob to select the pop-up ON/OFF of your own station's transmission
beacon (relayed signal).
Factory default value: OFF
8
Press the [DISP] key or press the PTT switch to return to the operating screen.
Display to notify reception of the same beacon or message
When receiving the same beacon or message from the same partner station, the following
screen is displayed. The display time is according to the setting in "75 APRS popup" of the
setup menu in the previous section.
A 2-digit letter is displayed
The first two alphabetical characters displayed in front of the callsign of the partner station
contain the following meaning.
First digit
N = New: New signal
D = Duplicate: Received signal
A = ACK: Message ACK signal (page 35)
R = Reject: Message REJ signal (page 31)
20