Yaesu FTM-200DE Instruction Manual page 48

LOW SPEED:
RATE LIMIT:
y 83 DIGI PATH
Setting the digipeater route.
Setting item: OFF / WIDE1-1 / WIDE1-1,WIDE2-1 / PATH 1 / PATH 2 / PATH 3 / PATH 4
/ FULL 1 / FULL 2
Default: WIDE1-1
Explanation:
A station that relays packets, such as beacons, is called a digipeater.
Select a CALLSIGN or ALIAS of the digipeater you would like to use.
In this transceiver, [WIDE1-1] (setting for 1 relay station) and [WIDE1-1/WIDE2-1] (setting
for 2 relay stations) is the default.
In [WIDE1-1, WIDE2-1], a transmission is relayed to the first digipeater station specified
as WIDE1-1, then to the second digipeater station specified as WIDE2-1.
In the USA, digipeater stations used by APRS are customarily operated using *New-
Paradigm.
The initial values set to this transceiver are premised for digipeater stations operating with
New- Paradigm, because most digipeater stations support this method.
In order to use other relay methods, select one of PATH 1 to PATH 4, FULL 1 or FULL 2,
and enter the CALLSIGN or ALIAS.
* For information on the New-Paradigm method, refer to the following website for details.
http://aprs.org/fix14439.html
y 84 DIGI PATH 1
Setting the digipeater route addresses.
Setting item: ADDRESS 1
ADDRESS 2
Default: –––––– – –
Explanation: Enter specific address information (callsign and alias) when "PATH 1" is
selected in [83 DIGI PATH] in the setup menu.
A maximum of up to 2 addresses can be specified.
Set the cut-off value for determining when the station has
stopped for whenb "DECAY" is set to ON. When the speed
is lower than the value set, the station will be deemed to
have stopped.
Set the timer for limiting automatic transmission from the
last beacon transmission to a certain period of time.
This prevents the beacon from being sent out twice
continuously within a short period of time when "DECAY" is
set to ON in the stationary state, and movement is detected
immediately after the beacon is automatically transmitted.
The beacon will not be automatically transmitted within this
period of time. Only when the set time has passed will the
beacon be automatically sent out again.
47