The External Monitor Is Blank Or The Image Is Unstable (Under Windows); The Notebook Cannot Be Started - Fujitsu Siemens Computers AMILO A1650G Operating Manual

The external monitor is blank or the image is
unstable (under Windows)
The wrong external monitor has been selected or the wrong screen resolution has been set for the
application programme.
Ê
Terminate the application programme in Windows with [Alt] + [F4]. If the fault continues to
occur after ending the programme, switch over to the notebook's internal LCD screen with [Fn]
+ [F5] and carry out the following routine:
Ê
Select the correct monitor or set the correct screen resolution.
−
Setting the screen resolution: Select Start - Settings - Control Panel - Display - Settings and
then the screen resolution you require in the Resolution field.
−
Selecting the monitor: Select the correct monitor under Start - Settings- Control Panel -
Display - Settings - Advanced Properties - Monitor - Modify.

The notebook cannot be started

The battery is not installed correctly
Ê
Switch the notebook off.
Ê
Check whether the battery is installed correctly in its compartment.
Ê
Switch the notebook on.
The battery is dead
Ê
Charge the battery.
or
Ê
Install a charged battery.
or
Ê
Connect the power adapter to the notebook.
The power adapter is not connected correctly
Ê
Switch the notebook off.
Ê
Check whether the power adapter is connected correctly to the notebook.
Ê
Check whether the power cable is plugged properly into the power adapter and into the mains
outlet. The indicator on the power adapter should illuminate.
Ê
Switch the notebook on.
The notebook is prevented from booting by a disk in the floppy disk drive.
Ê
Check whether this floppy disk is a system disk. Remove the floppy disk.
Operating system files may be damaged or missing.
Ê
Boot the notebook with a system floppy disk, via the floppy disk drive.
SAP:10600366086
Troubleshooting and tips
53