Other Programming; Registering A Unit - Panasonic 2-LINE KX-TG9551 Series Operating Instructions Manual

Programming
Base unit
1
MMENUN#217
2
MbN: Select the desired entry.
R To exit, press MEXITN.
3
To edit a number:
MEDITN a Edit the phone number. a
MSAVEN a MEXITN
To erase a number:
MERASEN a MbN: "Yes" a MSELECTN a
MEXITN
Note for handset and base unit:
R When viewing, "Block w/o num."
*2
is displayed if the blocking
w/o number"
incoming calls without phone number feature is
turned on. To turn the feature off: MERASEN a
MCN a MSAVEN a MOFFN (Handset) or MEXITN
(Base unit)
*1 Handset
*2 Base unit

Other programming

Changing the handset name
Each handset can be given a customized name
("Bob", "Kitchen", etc.). This is useful when you
make intercom calls between handsets. You can
also select whether or not the handset name is
displayed in standby mode. The default setting is
"No". If you select "Yes" without entering any
handset name, the default handset name will be
displayed (for example, "Handset 1").
Handset
1
MMENUN#104
2
Enter the desired name (max. 10 characters).
3
MSAVEN
4
MbN: Select the desired setting. a MSELECTN
2 times a MOFFN

Registering a unit

Operating additional units
Additional handsets
KX-TG9541/KX-TG9542
46 For assistance, please visit http://shop.panasonic.com/support
KX-TG954x_955x_OI(en)_0507_ver432.pdf 46
Up to 6 handsets can be registered to the base
unit.
KX-TG9551/KX-TG9552
Up to 12 handsets can be registered to the base
unit.
Important:
R See page 4 for information on the available
model.
Registering a handset to the base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset is
*1
/"Block
not registered to the base unit, re-register the
handset.
1
Handset:
MMENUN#130
2
Base unit:
Press and hold MLOCATORN for about 5
seconds until the registration tone sounds.
R If all registered handsets start ringing, press
MLOCATORN again to stop, then repeat this
step.
3
Handset:
Press MOKN, then wait until a long beep
sounds.
Deregistering a handset
A handset can cancel its own registration to the
base unit, or other handsets registered to the
same base unit. This allows the handset to end its
wireless connection with the system.
Handset / Base unit
1
MMENUN#131
R All handsets registered to the base unit are
displayed.
2
MbN: Select the handset you want to cancel.
a MSELECTN
3
MbN: "Yes" a MSELECTN
4
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
2018/05/07 14:00:44