Multiple Exposure - FujiFilm Finepix S2 Pro Owner's Manual

AUTO EXPOSURE BRACKETING
Compose picture, focus and shoot. A bracketing bar graph in the top display panel shows
3
the photography status each time a shot is taken.
h When three shots are to be taken, "
appears after the first shot, "
disappears when shooting is completed.
h If you hold the shutter button down when the "
selected, shooting automatically stops when the specified number of shots has been
taken. Note that shots are taken one frame at a time when the built-in flash is used.
h If the exposure compensation function (➡P.54) or flash exposure compensation (➡P.67)
is also set, Bracketing will be combined with the exposure compensation values. It is
useful to perform Bracketing with a compensated value of over +2 EV or under –2 EV.
h To cancel the Bracketing, rotate the Main-Command Dial while pressing the "
so " " disappears from the top display panel or perform Two-Button Reset (➡P.95). The
number of shots and compensated EV values previously selected will remain when they
are cancelled with the Main-Command Dial, and they automatically reset to "
when the Two-Button Reset is performed.
CSM1: Bracketing order can be set to change from negative EV value to positive EV value
(➡P.97).
56
" is shown before shooting begins, "
" appears after the second shot, and the bar graph
" (Continuous shooting) release mode is

MULTIPLE EXPOSURE

This is a photography technique that allows you overlay photographed images on top of each
other. You can use this technique to compose shots that cannot be obtained normally.
"
1
" button
"
2
N
Standard compensation value in Multiple exposure
In multi-exposure, a number of images are shot in the same frame. When you are overlaying
backgrounds and subjects, you must set the appropriate exposure offset before taking any shots.
I General guide to exposure offsets
Number of exposures
Two
Three
Four
Hold down the release mode switch unlock
button and set the release mode switch to "
(multi-exposure). When you select multi-
exposure mode, the "
viewfinder display.
According to the photography conditions, hold
down the " " (exposure compensation) button
1 as you turn the main command dial 2 to set
0 1
the exposure offset.
2 0
N
h Test shooting is recommended since the
Compensation value
compensation actually required varies
depending on the shooting situation.
h When the background is completely dark and
subjects do not overlap, no compensation is
necessary for each shot.
"
" icon appears in the
3
57
Continued over page...