Loading The Media; Smartmedia™ (Optional); Microdrive (Optional: Supplied By Another Manufacturers) - FujiFilm Finepix S2 Pro Owner's Manual

LOADING THE MEDIA

You can use either SmartMedia or Microdrive as recording media in the FinePix S2 Pro.
h If a SmartMedia and Microdrive are both loaded into the camera at the same time, images are
recorded on the media selected in SET–UP (➡ "Setup" P.89).
h Data cannot be copied between the two media types on the FinePix S2 Pro.
( optional )
SmartMedia TM
Always use 3.3-volt SmartMedia.
h MG-4S (4MB)
h MG-8S (8MB)
h MG-16S (16MB)
h MG-16SW (16MB, ID)
h MG-32S (32MB)
h MG-32SW (32MB, ID)
h MG-64SW (64MB, ID)
h MG-128SW (128MB, ID)
G
!
Images cannot be recorded or erased if a write-
protect sticker is affixed to the SmartMedia.
G
!
Operation of this camera is only guaranteed when it
is used with FUJIFILM SmartMedia.
G
!
Some 3.3V SmartMedia are labeled as "3V" or "ID"
cards.
G
!
See P.113 for more information on using SmartMedia.
1
2
Access lamp
20
Microdrive ( optional: supplied by another manufacturers)
h Microdrive 340MB
h Microdrive 1GB
G
!
Microdrives are actually very small and light hard
disks. Because they are a spinning storage medium,
they are less resistant to vibration and impacts than
SmartMedia. If you are using a Microdrive, take great
care not to expose the camera to vibration or impacts
(particularly during recording or playback).
G
!
The use of Ni-MH (nickel-metal hydride) batteries is
recommended when using as Microdrive.
G
!
See P.113 for more information on using Microdrive.
Some CompactFlash TM cards may not work
properly. Please contact the card manufacture
for compatibility.
Set the power switch to "OFF" and check that
the Access lamp is off. Then open the slot cover.
1
Never open the media slot cover while the
camera is switched on.This could destroy the
image data or damage the SmartMedia itself.
2
SmartMedia
Gold marking
Align the contact area (gold-colored
section) on the SmartMedia with the gold
marker on the SmartMedia slot and push
the SmartMedia firmly all the way into the
slot.
G
!
If you open the slot cover while the camera is still switched on, the camera is switched off as a safety
measure.
G
!
If the media is oriented incorrectly, it will not go all the way into the slot. Do not apply excessive force when
inserting a SmartMedia or Microdrive.
3
N N
Replacing a SmartMedia
Set the power switch to "OFF", check that
the Access lamp is off and then open the slot
cover. If you push the SmartMedia gently
into the slot, it pops out for easy removal.
G
!
When storing SmartMedia, always use the
special anti-static case provided.
Microdrive
Push the Microdrive firmly all the way into
the Microdrive slot.
Close the slot cover.
N N
Replacing a Microdrive
Set the power switch to "OFF", check that
the Access lamp is off and then open the slot
cover. Then press the eject button and
remove the Microdrive.
Eject button
G
!
When storing Microdrives, always use the special
protective case provided.
1
21