GBC 44DT Installation & Operation Manual page 24

44DT
Operating Instructions
C PSA F
ONFIGURATION FOR ILMS
PSA films are loaded with the top supply shaft
assembly in the rear position as shown in Fig. 6-12.
Notice that the supply shaft is mounted on the rear
of the machine.
The brake and support must be positioned in the
rear position for PSA films. To move the supply shaft,
see To move the supply shaft in the Configuration for
Thermal and Accushield Films section.
Fig. 6-9. Configuration for Thermal Film.
Fig. 6-11. Supply Shaft and Brake Assemblies Mounted
on the Rear Position.
Take-up
PSA Film
Fig. 6-10. Configuration for AccuShield Film
Release liner
PSA mounting film or kraft paper
Fig. 6-12. Configuration for Poly-in PSA Film.
Page 6-7