Preparations; Settings On The Control Terminal - Sony BKS-R3210 Operation Manual

Preparations

Settings on the Control Terminal

Before switching signals with this unit, the following
preparations should be made on the control terminal
connected to the primary station of the S-BUS data
link.
For details on making the settings, refer to the Installation
Manual supplied with the routing switcher.
1
Set the type names of sources, such as VTR, FLM,
AUX, etc.
Up to 16 type names may be set.
2
Set the source names using a type name and
number from 001 to 999, such as FLM034.
A list of the registered source names is called the
source table.
3
Set the destination names using a type name and
number from 001 to 999, such as VTR089.
A list of the registered destination names is called
the destination table.
4
Set the phantom names.
A list of the registered phantom names is called the
phantom table.
5
Set the selection method; type-number selection or
direct selection.
6
When direct selection is set:
Assign sources and destinations to the select
buttons.
When type-number selection is set:
Select the destination names from the destination
table for the BKS-R3210. A list of the selected
destination names is called the available
destination table. The selectable sources for these
available destinations can be limited. These
sources are called available sources.
This step is not necessary if you wish to use all the
sources and destinations.
7
Set the level to be controlled.
12 (E)
8
Set the mother unit and daughter units when
multiple control units are to be used in
combination as follows:
For the mother unit
PANEL mode: MOTHER
SET BLOCK NUMBER: Block number used (1
through 10)
For daughter units
PANEL mode: DAUGHTER
MOTHER STATION ID: Station ID of the mother
unit
Note
Set the mother unit first.
9
Make the route setting if the route function is to be
used.