Advertisement
Setting with a 16-source selector (direct
selection)
While holding down buttons 1 and 4 (or buttons 5 and
7), turn the power on.
All the 16 source/destination select buttons work as
source select buttons.
To select a destination, press to turn on the DEST
button and turn the SELECTOR knob.
Setting with a 8-source/8-destination selector
(direct selection)
While holding down buttons 5 and 6, turn the power
on.
The upper buttons 1 through 8 work as source select
buttons, and the lower buttons 9 through 16 work as
destination select buttons.
Setting with phantom full-protect mode
While holding down buttons 9 and 11, turn the power
on.
If one of the crosspoints set for a phantom is protected,
switching of all the crosspoints of the phantom is
prohibited.
Setting with phantom partial-protect mode
While holding down buttons 9, 10 and 11, turn the
power on.
If one of the destinations set on a phantom is protected,
switching of the crosspoints, including the protected
destination is prohibited, but the other crosspoints are
switched.
List of setup operations
Settings
Initialization
Multi level mode
Single-level mode
Single-use mode
Type-number selection
Direct selection
Prompt lamp-light mode
Status display mode
16-source selector
8-source/8-destination selector
Phantom full-protect mode
Phantom partial-protect mode
Buttons to be pressed
1, 2
1, 6
1, 7
5, 8
6, 7, 8
7, 8
1, 3
1, 2, 3
1, 4 (or 5, 7)
5, 6
9, 11
9, 10, 11
15 (E)
Advertisement
Chapters
