Hard drive
NOTE:
The hard drive spare part kit does not include the bracket, connector cable, Mylar shield,
or screws. The bracket, connector cable, Mylar shield, and screws are included in the Hard Drive
Hardware Kit, spare part number 665597-001.
NOTE:
The computer can be equipped with up to two hard drives. The primary hard drive is installed
in the right hard drive bay. The secondary hard drive is installed in the left hard drive bay.
Description
1-TB, 5400-rpm, 12.7-mm
750-GB, 7200-rpm, 9.5-mm
750-GB, 5400-rpm, 9.5-mm
640-GB, 5400-rpm, 9.5-mm
500-GB, 7200-rpm, 9.5-mm
500-GB, 5400-rpm, 9.5-mm
320-GB, 7200-rpm, 9.5-mm
320-GB, 5400-rpm, 9.5-mm
160-GB solid-state drive (does not include bracket, connector cable, Mylar shield, or screws)
Before removing a hard drive, follow these steps:
1.
the computer on, and then shut it down through the operating system.
2.
3.
4.
5.
Remove the hard drive:
NOTE:
Steps 1 through 3 apply to the primary hard drive. See steps 4 through 7 for secondary
hard drive removal information.
1.
Disconnect the hard drive cable (1) from the system board.
2.
Remove the four Philllips PM2.5×5.0 screws (2) that secure the hard drive to the computer.
47).
48).
Component replacement procedures
Spare part number
638974-001
633252-001
634250-001
603785-001
608218-001
634932-001
634862-001
622643-001
665985-001
51