ZyXEL Communications GS2220 Series User Manual page 307

The following table describes the labels in this screen.
Table 151 Advanced Application > PPPoE > Intermediate Agent > VLAN
L ABEL DESC RIPT IO N
Show VLAN Use this section to specify the VLANs you want to configure in the section below.
Start VID Enter the lowest VLAN ID you want to configure in the section below.
End VID Enter the highest VLAN ID you want to configure in the section below.
Apply Click
Apply
VID This field displays the VLAN ID of each VLAN in the range specified above. If you configure the
VLAN, the settings are applied to all VLANs.
* Use this row to make the setting the same for all VLANs. Use this row first and then make
adjustments on a VLAN-by-VLAN basis.
Changes in this row are copied to all the VLANs as soon as you make them.
Enabled Select this option to turn on the PPPoE Intermediate Agent on a VLAN.
Circuit-id Select this option to make the Circuit ID settings for a specific VLAN take effect.
Remote-id Select this option to make the Remote ID settings for a specific VLAN take effect.
Apply Click
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
Chapter 32 PPPoE
to display the specified range of VLANs in the section below.
to save your changes to the Switch's run-time memory. The Switch loses these
to begin configuring this screen afresh.
GS2220 Series User's Guide
307
link on the top navigation panel to save
Sa ve
*