Installing The Mower Deck - Toro TimeCutter HD ZX4800 Operator's Manual

Removing the Mower Deck
1. Remove the hairpin cotter and washer securing the
link pin to the frame and deck, and remove the link
bar (Figure 63).
Figure 63
1. Link pin
2. Washer
2. Lift up the mower deck to relieve tension from the
mower deck.
3. Remove the chains from the hooks on the deck-lift
arms (Figure 64).
Figure 64
1. Deck-lift arm
2. Chain
4. Raise the height of cut to the transport position.
5. Remove the belt from the clutch pulley on the engine.
6. Slide the mower out from underneath the machine.
Note: Retain all parts for future installation.
g028276
3. Hairpin cotter
g024313
3. Hook
4. Adjustment bolt

Installing the Mower Deck

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the
N -L
EUTRAL OCK
the key from the key switch, engage the parking brake,
and wait for all moving parts to stop before leaving the
operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest position.
5. Place the height-of-cut pin in the lock position for
lowest height of cut.
6. Lift the rear of the mower deck and attach the chains
to the rear lift arms
7. Attach the front chains to the front lift arms
64).
8. Install the long link bar through the frame hanger and
deck.
9. Secure the link pin with the hairpin cotters and washers
removed previously
10. Install the mower belt onto the engine pulley; refer to
Replacing the Mower Belt (page
42
position, shut off the engine, remove
(Figure 64).
(Figure 63).
44).
(Figure