Applied Control - Toshiba MMK-AP0073HP1-E1 Service Manual

6-1. Indoor Unit
6-1-1. Setup of Selecting Function in Indoor Unit
(Be Sure to Execute Setup by a Wired Remote Controller)
<Procedure> Execute the setup operation while the unit stops.
3
5
6
1
1
CL
SET
Push , , and
The firstly displayed unit No. indicates the header indoor unit address in the group control.
In this time, the fan of the selected indoor unit is turned on.
2
UNIT LOUVER
Every pushing
displayed. In this time, the fan of the selected indoor unit only is turned on.
3
Specify the item code (DN) using the setup temperature
4
Select the setup data using the timer time
(When selecting the DN code to "33", change the temperature indication of the unit from "°C"
to "°F" on the remote controller.)
5
SET
Push button. (OK if display goes on.)
• To change the selected indoor unit, return to procedure
• To change the item to be set up, return to procedure
6
TEST
Pushing button returns the status to normal stop status.

6. APPLIED CONTROL

TEMP.
TIMER SET
TIME
FILTER
RESET TEST SET
TEST
buttons simultaneously for 4 seconds or more.
button, the indoor unit numbers in the group control are successively
ON / OFF
FAN MODE
SAVE VENT
CL SWING/FIX UNIT LOUVER
and
and buttons.
2
.
3
.
68
FILE NO. SVM-16046
4
2
buttons.