Toshiba MMK-AP0073HP1-E1 Service Manual page 153

No. Part name
R
Electric parts 1) Perform work of item
assembly
2) Take off PMV cover fixing screws (2 pcs.)
3) Take off drain guide fixing screws (2 pcs.)
4) Take off earth screw (1 pc.) fixed to the
5) Pull out TC1, TC2 and TCJ sensors from
6) Take off the connector cover mounting
7) Take off the clamp base mounting screw
8) Remove the binding band and then
9) Disengage the display unit by simply
10) Remove the fixing screw that secures
Same as reassembly pace Addition of the
following cautions
<Cautions in reassembling>
Mount the electric parts box to the main unit
in the reverse order to the removing procedure.
Determine the sensor positions and lead
wire drawing as same as those before
removing according to the figure.
Procedures
Q
and then remove PMV cover.
and then remove the drain guide.
end plate.
the sensor holder of the heat exchanger.
(When reassembling the electric parts, be
careful to the attaching positions of every
sensor. TC2 and TCJ sensors resemble in
the shapes, so distinct them by marking,
etc. when mounting them.)
screw (1 pc.) and then remove the
connector cover.
(1 pc.) and then remove the clamp base.
remove the fan motor connector (5P), the
connector (5P) for louver motor
(When mounting the P.C. board, fix the
lead wires again by the binding band.)
Tighten the binding band at the same
position before removing.)
pushing at the top of the display unit.
the electric parts box assembly, LED
assembly and remove the assembly.
.
Drain guide
Drain guide Drain guide Drain guide
fixing screw fixing screw fixing screw
Earth screw Earth screw Earth screw
Connector cover Connector cover Connector cover
TC2 sensor ( TC2 sensor (Ø6) TC2 sensor (Ø6) 6)
Clamp base Clamp base Clamp base
Fan motor connector Fan motor connector Fan motor connector
Binding Binding
153
FILE NO. SVM-16046
Remarks
PMV cover PMV cover PMV cover
PMV cover fixing screw PMV cover fixing screw PMV cover fixing screw
Connector cover
fixing screw
TCJ sensor
(Ø6 sleeve provided)
TC1 sensor (Ø4) TC1 sensor (Ø4) 4) TC1 sensor (
Fixing screw Fixing screw Fixing screw
ban band d