Table of Contents
Advertisement
Turning Power On and Off
1
Press the SOURCE/POWER button to turn on
the unit.
NOTE
The unit can be turned on by pressing any other button
except the eject c button.
The volume level gradually increases to the
previous level you were listening to before the
unit was turned off.
Press and hold the SOURCE/POWER button
again for at least 3 seconds.
NOTE
The very first time the power is turned on, the volume
will start from level 12, and the LOUD function will be
on in the tuner mode.
Adjusting Volume/Balance
(Between Left and Right)/Fader
(Between Front and Rear)
1
Press the MODE/LOUD button repeatedly to
choose the desired mode.
Each press changes the modes as follows:
→ VOL → SUB-W* → BAL → FAD
Volume: 0 ~ 35
Balance: L15 ~ R15
Fader: R15 ~ F15
Subwoofer: 0 ~ +15
NOTES
• If the Rotary encoder (CDM-9807RB/CDM-9805R
only) is not turned or the 5 or 6 button (CDM-
9803RM/CDM-9803R/CDE-9802RB/CDE-9801R
only) is not pressed in 5 seconds after selecting the
BALANCE and FADER modes, the unit automatically
sets in the VOLUME mode.
• *When the subwoofer is set to ON, the level of the
subwoofer can be adjusted.
2
Turn the Rotary encoder (CDM-9807RB/CDM-
9805R only) or press the 3 3 3 3 3 and 4 4 4 4 4 buttons
(CDM-9803RM/CDM-9803R/CDE-9802RB/CDE-
9801R only) until the desired sound is obtained
in each mode.
Turning Loudness On/Off
Loudness introduces a special low- and high-
frequency emphasis at low listening levels. This
compensates for the ear's decreased sensitivity
to bass and treble sound.
1
Press and hold the MODE/LOUD button for at
least 2 seconds to activate or deactivate the
loudness mode. The display shows "LOUD ON"
when the loudness mode is activated.
Audio Mute Function
Activating this function will instantly lower the
volume level by 20 dB.
1
Press the MUTE button to activate the MUTE
mode. The audio level will decrease by about 20
dB.
Pressing the MUTE button again will bring the
audio back to its previous level.
Indicators on the CDM-9807RB/CDM-9805R/
CDM-9803R
The underline is lit when the function is activated.
FR
ES
DE
IT
SE
5
-EN
Advertisement
Table of Contents
