Getting Started; Accessory List; Turning Power On And Off; Demonstration Function - Alpine CDE-196DAB Owner's Manual

Getting Started

 CDE-196DAB
Rotary encoder
/SOURCE
/ENTER

/SETUP
/
e
 UTE-93DAB
Rotary encoder
/SOURCE
/ENTER

AUDIO/SETUP
/
e
Note
• The buttons on this Owner's Manual use CDE-196DAB as an example.

Accessory List

• Head Unit ..................................................................................1
• Power Cable ..............................................................................1
• Microphone ..............................................................................1
• Mounting Sleeve ......................................................................1
• Carrying Case............................................................................1
• Rubber Cap ...............................................................................1
• Hex Bolt.....................................................................................1
• Bracket Key ...............................................................................2
• Screw (M5 × 8) ..........................................................................4
• Owner's Manual..................................................................1 set

Turning Power On and Off

Press t to turn on the unit.
Note
• The unit can be turned on by pressing any other button except 
(CDE-196DAB only) and e (Release).
Press and hold t for at least 2 seconds to turn off the
unit.
Note
• The first time power is turned on, the volume will start from level 0.

Demonstration Function

This unit will enter a demonstration mode to display its various
functions. When Demo mode is set to ON (initial setting), the unit starts
the demonstration if there is no operation for 30 seconds.

Turning the Demonstration mode Off

/DIM.
There are two methods to close the demonstration mode.
Method 1:
When installing this unit in a car for the first time, the DEMO OFF screen
will be displayed for 20 seconds after turning on the unit. Press
ENTER within 20 seconds to put the demonstration mode into
*
standby state .
Method 2:
Setting DEMO MODE to OFF (standby state
*
closed state ) in Setup menu.
* For details about standby state and completely closed state, please refer
to "Demonstration" on page 30.

Source Selection

Press VSOURCE to change the source.
TUNER  DAB+/DMB  DISC
*3
 AUXILIARY
BT AUDIO
*1 CDE-196DAB only.
*2 Displayed only when the iPod/iPhone is connected.
*3 Displayed only when BT IN is set to ON, refer to "Setting the
Bluetooth Connection (BT IN)" on page 36.
*4 Refer to "Using the Front AUX Input Terminal" on page 26.

Detaching and Attaching the Front Panel

Detaching

Notes
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it may
result in malfunction.
*
) or QUITE OFF (completely
*1 *2
 USB AUDIO/iPod 
*4
 TUNER
9
-EN