Basic Operations; Detaching The Front Panel; Attaching The Front Panel; Initial System Start-Up - Alpine CDM-9805R Owner's Manual

Basic Operations

(CDM-9807RB/CDM-9805R)
SOURCE/
POWER MODE / LOUD (Rotary encoder)
MUTE

Detaching the Front Panel

1
Press and hold the SOURCE/POWER button for
at least 3 seconds to turn off the power.
2
Press the (Release) button at lower left corner
until the front panel pops out.
3
Grasp the left side of the front panel and pull it out.
NOTES
• The front panel may become hot in normal usage
(especially the connector terminals), this is not a
malfunction.
• To protect the front panel, place it in the supplied
carrying case.

Attaching the Front Panel

1
First, insert the right side of the front panel into
the main unit. Align the groove on the front panel
with the projection on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
2
NOTE
Before attaching the front panel, make sure that there is
no dirt or dust on the connector terminals and no
foreign object between the front panel and the main unit.
4
-EN
1 1
(CDM-9803RM/CDM-9803R/CDE-9802RB/CDE-9801R)
SOURCE/
4
MODE / LOUD
POWER
3
MUTE
• Controllable With Remote Control
(CDM-9807RB/CDM-9805R/CDM-9803RM/
CDM-9803R only)
This unit can be controlled with an optional
Alpine remote control. For details, consult your
Alpine dealer.
Point the optional remote control transmitter at
the remote control sensor.
Remote control sensor
• Connectable to Remote Control Interface Box
(CDM-9807RB/CDM-9805R/CDM-9803RM/
CDM-9803R only)
You can operate this unit from the vehicle's
control unit when an Alpine Remote Control
Interface Box (optional) is connected. For
details, contact your Alpine dealer.

Initial System Start-Up

1
Immediately after installing or applying power to
the unit, it should be initialized. To do this, first,
remove the detachable front panel. Behind the
front panel, to the right of the connector, there is
a small hole. Using a pencil or other pointed
object, press the Reset switch mounted behind
this hole to complete the initialization procedure.
1
Reset switch