JVC KD-R491 Schematic Diagrams page 45

4.7.2 ERROR CODE for MODEL with FLM-HCI MECHA (Ver1.1)
DISPLAY SIGN ERROR Item
LI-E LOADING TIME OVER
EJ-E EJECT TIME OVER
E-04 READ ERROR
E-14 FOCUS ERROR
E-05 UNKNOWN DISC
E-20 NODISC ERROR
E-21 DSP ACCESS ERROR In RUNNING MODE operating
E-22 LIM SW ERROR
AE-01
AE-02
AE-03
AE-04
AUTO ADJUSTMENT
ERROR
AE-05
AE-06
AE-07
AE-08
4.8 Tuner Span Change Mode
Pressing and holding [VOLUME] key, then press [RETURN] key for 3 seconds.
4.8.1 Default status immediately after the mode activation
It shall be same as normal activation.
After selection of the setting item, the receiver should exit this mode and return to the display before entering this mode.
This setting will be stored in EEPROM.
4.8.2 Mode content
Syscon shall display the following information after entering this mode.
Item Operation
Tuner Span VOLUME
Change Mode (*1) +/-
Tuner Span
Change Mode (*2)
VOLUME
+/-
Tuner Span
Change Mode (*3) VOLUME
+/-
Release Mode VOLUME
*1: Only applicable for Asia ('U') models
*2: Only applicable for Europe ('E') models
*3: Only applicable for Australia ('X') models
Condition
In LOAD operating.
In EJECT operating.
In RUNNING MODE operating
In RUNNING MODE operating
In RUNNING MODE operating
In RUNNING MODE operating
In RUNNING MODE operating
In RUNNING MODE operating
In RUNNING MODE operating
In RUNNING MODE operating
In RUNNING MODE operating
In RUNNING MODE operating
In RUNNING MODE operating
In RUNNING MODE operating
In RUNNING MODE operating
Display content
A S I A
A S I A G E N
A U S
O T H E R S
E U R O P E
M . E A S T
A R E A T U R
A U S
A S I A G E N
O T H E R S
(No.MA665<Rev.001>)26/33
Anomaly detection of SW state at LOADING.
Or 5 sec TIME OVER from LOAD start.
Anomaly detection of SW state at EJECT.
Or 5 sec TIME OVER from EJECT start.
TOC read error.
Focus Error. No complete Focus ON.
No reflection.
In case of DISC distinction.
fails in the access to DSP.
Time over in case of that moves to an inner side.
Focus Gain Error
Tracking Gain Error
RF Gain Error
Tracking Balance Error
Focus Balance Error
Focus Offset Error
Tracking Offset Error
RF Offset Error
default span is for Asia area
* - use Tunisia as based frequecy (AM) and tuner pa-
rameter still follow Asia.
Change to 'Asia' Span type.
E R A L
Change to 'Australia' area type.
Change to 'US' area type.
Default setting for Europe models.
Change to 'Europe' area type.
Turkish language setting will be hiding in setup menu
Change to 'Tunisia' area type.
Default language change to Turkish
K E Y Turkish language setting is available in setup menu
Change to 'Australia' area type.
Change to 'Asia' Span type.
E R A L
Change to 'US' area type.
Depending on display pattern in normal mode.
Details
Details