JVC KD-R491 Schematic Diagrams page 32

• NOTICE FOR HANDRIG OF FEED MOTR ASSY
CAUTION: For mounting FEEDMOTOR ASSY, DON'T bump this part.
Because handling may cause this part easily deformed.
WORM 1
• NOTICE FOR HANDRIG OF ROLLER LEVER ASSY
OK
• NOTICE FOR CLAMPER ASSY OF PICK UP ASSY
OK
• NOTICE FOR HANDRIG OF MD CHASSIS ASSY
Handle CHASSIS part.
• NOTICE FOR HANDRIG OF PICK UP ASSY
OK
FEED MOTOR
NG
Do not handle roller part.
NG
Do not handle
the clamper part.
NG
OK
Do not handle the
turn table part.
NG
Do not handle the lens part.
(No.MA665<Rev.001>)13/33
3.2.1 Removing the CD MECHA PWB (See Fig.1 to 3)
(1) Solder the short land on the PICKUP. (See Fig.1)
SOLDER
(2) Remove the 6 wires from the CD MECHA PWB. (See
Fig.2)
(3) Disconnect the FPC wire from the connector
Player unit). (See Fig.3)
(4) Remove the 3 screws A, and remove the CD MECHA
PWB. (See Fig.3)
Fig.1
Black
Red
Yellow
Orange
White
Orange
Fig.2
CN2
A
CN2
CD MECHA PWB
Fig.3
(CD
A