Jmp2 Setting For Logic '1; Jmp2 Setting For Logic '0 - Texas Instruments BUF18830EVM User Manual

www.ti.com
Using the BUF18830 Software
2
2.3.1 I C Address Selection
As mentioned previously in the BUF18830EVM-USB Features section (see
2
used to set the I C address pin of the BUF18830.
both be set to allow for communication between the BUF18830EVM and the software. Without jumper
JMP2 and the software address button configured correctly, the software will not be able to communicate
with the BUF18830 device.
When JMP2 and the software are set as
SBOU103A – April 2011 – Revised May 2016
Submit Documentation Feedback
Figure 16
Figure 16. JMP2 Setting For Logic '1'
Figure 17 shows, the second I
Figure 17. JMP2 Setting for Logic '0'
Copyright © 2011–2016, Texas Instruments Incorporated
BUF18830EVM Software
Section 1.8), jumper JMP2 is
shows how the hardware and software must
2
C address can be configured.
BUF18830EVM User Guide and Software Tutorial
17