Testing The Multipass C50 - Canon MultiPASSTM C50 User Manual

Testing the MultiPASS C50

After you have assembled your MultiPASS C50, installed a BJ cartridge, loaded
the print media, and entered your user identification information, you can make
sure the MultiPASS C50 is printing properly by making several copies of a
document. For instructions, see "Making Copies" on page 6-13.
2-74 Setting Up Your MultiPASS C50
If you are printing on plain paper, note the following:
If the printed sheets are curled as they exit the MultiPASS C50, remove
them from the output tray immediately to avoid paper jams.
Make sure your text or graphics fall within the printable area.
If the print head is printing past the edge of the paper and directly on the
platen, clean the platen. See "Cleaning the MultiPASS C50's Interior" on
page 9-2.
If you are printing on transparencies or back print film, note the following:
Remove each sheet of film after it exits from the unit. Do not let film
stack up on the output tray.
Allow printed film to dry before storing it. (Canon film needs about 15
minutes to dry properly.)
After the film dries, cover each printed side with a sheet of plain paper
before storing. This is necessary even if you put the film in a clear file.
Chapter 2