Table of Contents
Advertisement
Removing the bezel
When you work with some devices, such as additional optical drives, you must first
remove the bezel to access the device.
To remove the bezel, complete the following steps:
1. Remove the side cover (see "Removing the side cover" on page 17).
2. Read the safety information that begins on page v and the "Installation
3. Turn off the server and all attached devices (see "Turning off the server" on
4. From inside the server, locate the bezel release tab at the bottom of the bezel.
For instructions for replacing the bezel, see "Installing the bezel" on page 32.
18
System x3100 Type 4348: User's Guide
guidelines" on page 15.
page 10); then, disconnect all power cords and external cables.
Press the bezel release tab, and then pull the bottom of the bezel away from
the server to disengage the top bezel tabs from the server, and set the bezel
aside.
Bezel release tab
Advertisement
Table of Contents
