IBM x3100 User Manual page 37

Statement 3
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could result in
exposure to hazardous laser radiation. There are no serviceable parts inside the
device.
v Use of controls or adjustments or performance of procedures other than those
specified herein might result in hazardous radiation exposure.
Danger
Some laser products contain an embedded Class 3A or Class 3B laser diode. Note the
following. Laser radiation when open. Do not stare into the beam, do not view directly with
optical instruments, and avoid direct exposure to the beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
`
Appareil A Laser de Classe 1
6. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and
place it on a static-protective surface.
7. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
8. Remove the drive retainer clip (on the front of the chassis) for the bay in which
you want to install the drive (see the illustration on page 27). Slide the drive
retainer clip to the right to remove it from the chassis; then, snap the drive
retainer clip into the screw holes on the side of the drive (the blue side of the
drive clip should be facing outward).
9. Align the drive assembly with the guide rails in the bay. Push the drive into the
bay.
10. Connect one end of the signal cable into the back of the drive and make sure
that the other end of this cable is connected into the SATA attached connector
on the system board.
11. Route the signal cable so that it does not block the airflow to the rear of the
drives or over the microprocessor and DIMMs.
12. If you have another drive to install or remove, do so now.
13. Connect the power cable to the back of the drive. The connectors are keyed
and can be inserted only one way.
If you have other devices to install or remove, do so now; otherwise, go to
"Completing the installation" on page 31.
Chapter 2. Installing optional devices
25