Troubleshooting - Goldstar WG1005R Owner's Manual

Maintenance and Service

Troubleshooting

The air conditioner ma y be operating abnormally when:
Problem
Air
conditioner
does not
start
Air
conditioner
does not
cool as it
should
Air
conditioner
freezing up
24 Room Air Conditioner
Possible Causes
The air conditioner is
unplugged.
The fuse is blown/circuit
breaker is tripped.
Power failure.
The current interrupter
device is tripped.
Airflow is restricted.
The thermostat may not
be set high enough.
The air filter is dirty.
The room may have been
hot.
Cold air is escaping.
Cooling coils have iced up.
Ice blocks the air flow and
stops the air conditioner
from cooling the room.
What To Do
Make sure the air conditioner plug is
pushed completely into the outlet.
Check the house fuse/circuit
breaker box and replace the fuse
or reset the breaker.
If power failure occurs, turn the
mode control to Off.(Mechanical
Type).
When power is restored, wait 3
minutes to restart the air conditioner
to prevent tripping of the compressor
overload.
Press the RESET button located
on the power cord plug.
If the RESET button will not
stay engaged,
discontinue use of the air
conditioner and contact a qualified
service technician.
Make sure there are no curtains ,
blinds, or furniture blocking the
front of the air conditioner.
Turn the knob to a higher number
The highest setting provides
maximum cooling.
Clean the filter at least every 2
weeks.
See the care and Maintenance
section.
When the air conditioner is first
turned on, you need to allow time
for the room to cool down.
Check for open furnace floor
registers and cold air returns.
See Air Conditioner Freezing Up
below.
Set the mode control at High Fan
or High Cool with thermostat at 1
or 2.
.