Table of Contents
Advertisement
Available languages
Available languages
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start‑up
can cause injury.
WARNING: Use only D
Replacing the Dust Brush (Fig. L)
WARNING: Wear approved eye protection and approved
dust mask when performing this procedure.
The dust brush will wear during use and will need to
be replaced.
1. To remove the dust brush
17
small tabs
22
holding it in place.
2. Insert the new dust brush making sure it is securely held by
the four small tabs.
Optional Accessories
WARNING: Since accessories, other than those offered
by D
WALT, have not been tested with this product, use
e
of such accessories with this product could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
SDS plus® and SDS max® are registered trade marks of
Robert Bosch GmbH
WALT replacement parts.
e
, pry it away from the four
WALT recommended
e
EngLIsh
15
Advertisement
Table of Contents
