Specifications Hfc-202 - Teledyne 200 Series Instruction Manual

Hide thumbs Also See for 200 Series:
Table of Contents

Advertisement

200/202 Series Flowmeters and Controllers Instruction Manual

Specifications HFC-202

WARNING: Do not operate instruments exceeding the specifications listed below. Failure to
heed this warning could result in serious personal injury and/or damage to the equipment.
Accuracy
1
and Linearity:
Repeatability:
Standard Pressure Rating:
Pressure Coefficient:
High Pressure Option:
Control Valve Differential Pressure
Leak Integrity:
Operating Temperature:
Temperature Coefficient:
WARNING: Operation above 60 °C ambient may result in case temperatures capable of causing
burns.
Power (±15V controller, 0-5 VDC):
Power (±15V controller, 4-20 mA):
Power (24V controller, 0-5 VDC):
Power (24V controller, 4-20 mA):
NOTICE: Use of an underpowered or under-voltage supply could result in equipment damage.
Output Flow Signal / CMD Input:
Wetted Material
2
:
Connector:
Fittings:
Weight (approx.)
WARNING: Do not power with isolated drive circuits that are more than 36 volts above ground
potential or could reach 36 volts in the event of a fault. Failure to heed this warning could
result in serious personal injury and/or damage to the equipment.
Response Time (10-100%):
1 Stated accuracy is for nitrogen or other gas specific calibration and using this gas only.
2 Other materials are available. Viton is the standard O-ring option.
* Specifications may vary for instruments with ranges above 10 slm.
EAR99 Technology Subject to Restrictions Contained on the Cover Page
*
±1% of FS
±0.043% FS
500 psig
+0.0067%/psig (0-1000 psig N2) typical
Proof tested to 1500 psig
*
Per customer order
-9
Less than 1x10
sccs
-20°C to 70°C
Zero ±0.035% FS/°C (-20 to 70°C), Span ±0.06% FS/°C (-20 to 70°C)
+(14-16) VDC @ 21 mA, -(14-16) VDC @ 175 mA (~ 3.14 watts)
+(14-16) VDC @ 40 mA, -(14-16) VDC @ 175 mA (~ 3.44 watts)
(12-36) VDC ~ 3.64 watts
(13-36) VDC ~ 3.96 watts
0-5.00 VDC linear or 4-20 mA
316 & 302 SS, Ni, Viton®, Kalrez® 82/18 Au/Ni Braze, Trace Ag Solder
15-pin subminiature D / (9-pin for 24V)
¼-inch Swagelok®, others available
1.8 lb. (0.82 kg)
3.4 seconds typical, 3.5 seconds max
Page 8 of 27

Advertisement

Table of Contents
loading

This manual is also suitable for:

202 series

Table of Contents