Installing The Sata M.2 2280 Riser Option - HP HPE ProLiant DL365 Gen10 Plus Server User Manual

Installing the SATA M.2 2280 riser option

Installing the SATA M.2 2280 riser option
Prerequisites Prerequisites
Before installing this option, be sure that you have the following:
The components included with the hardware option kit
Up to two 2280 form factor M.2 drives
T-15 Torx screwdriver
Procedure Procedure
1. Power down the server (Power down the server).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack ( Extend the server from the rack ).
b. Remove the server from the rack ( Remove the server from the rack ).
4. Remove the access panel ( Remove the access panel ).
5. Remove the primary PCI riser cage ( Remove the primary PCI riser cage).
6. If needed, remove any expansion boards installed in the riser cage.
7. Remove the existing riser board from the riser cage.
8. Install the M.2 riser board.
Installing the SATA M.2 2280 riser option 91